Entry handling
Coil car, decoiler, snubber, pinch rolls and threading equipment.
Core line portfolio
Precision slitting lines.
European-engineered systems for stainless steel and metallic coil, integrating heavy-duty handling, precision cutting, scrap recovery, tension control and recoiling.
Turnkey in the USA
AVENOR supplies the complete line and retains responsibility for interfaces, controls, commissioning and acceptance.
Line architecture
From master coil to controlled slit coils.
Slitting section
Precision arbor system, tooling strategy and setup for the product mix.
Scrap recovery
Edge-trim management integrated with line speed and operating safety.
Tension control
Pit or alternative architecture selected around material and surface protection.
Recoiling
Separator, recoiler, unloading and finished-coil handling.
Controls
Recipes, drives, line synchronization, diagnostics and U.S. safety integration.
Technical definition
Capacity is engineered around the real cut program.
- Material
- Grade, yield strength, surface and edge requirements
- Coil envelope
- Maximum weight, width, thickness, ID and OD
- Cut program
- Number of cuts by thickness, minimum strip width and tooling
- Speed
- Defined by product mix, threading, inspection and output target
- Options
- Paper interleaving, protective film, bridle and automated tooling
- Compliance
- NFPA 79 / UL 508A strategy and OSHA-related safeguarding reviewed by project
All capacities are indicative until AVENOR validates the material matrix and issues guaranteed acceptance criteria.
Data required
Send the coil range and cut matrix.
- Material grades and mechanical properties
- Thickness and width range
- Maximum coil weight, ID and OD
- Required cuts by material thickness
- Minimum slit width and edge-quality requirement
- Target output, floor space and preferred pit arrangement